
140 VoIP
Parameter Value Description
TON
0–7
Specify the type of number to use as a filter for
tracing. Only calls using this TON setting are traced.
0 = All TONs
1 = Unknown Number
2 = International Number
3 = National Number
4 = Network Specific Number
5 = Subscriber Number
6 = L1 Regional Number
7 = L0 Regional Number
MsgRecv
ON, OFF Enables or disables tracing on messages sent to the
specified channels.
MsgSend
ON, OFF Enables or disables tracing on messages sent from
the specified channels.
H323GwShow
Syntax:
H323GwShow
Prints a snapshot summary of the state of the virtual trunk settings.
The following example shows command output.
oam> H323GwShow
Npm status: Active
Active GateKeeper: 192.168.19.51 (primary)
GateKeeper registration status: registered, TTL: 25 secs,
re-register: 12 secs
Channels Busy / Idle / Total: 0/6/6
Stack version: RadVision 4.1.0.19 Channel tracing: -1
Signaling Server H323 ID : SS_N318
H323GwShow ch channelNum
Syntax:
H323GwShow ch channelNum
Display a snapshot summary of the state of the virtual trunk settings plus
the snapshot of the active call on the specified channel if the call exists.
The following table describes the command parameters.
Nortel Communication Server 1000
Troubleshooting Guide for Distributors
NN43001-730 02.02 31 December 2009
Copyright © 2008-2009 Nortel Networks. All Rights Reserved.
.
Komentáře k této Příručce